Which Way Do Rear Shocks Go
Which Way Do Rear Shocks Go. Always use specialised tools for each type of application. Our theory is that it's a lot harder to nick a hardened steel shaft to the point of.
Our theory is that it's a lot harder to nick a hardened steel shaft to the point of. Finish removing the nut and tap out the bottom shock bolt using a rubber mallet. The correct way to install it is with the boot on top and the logo facing the correct way.
If The Nut Almost Spun Off, Apply A Film Of.
Joined nov 16, 2007 · 4 posts. The correct way to mount it is as shown with the boot down and the label facing so it is not upside down. Shock absorbers should always be fitted in pairs.
Always Use Specialised Tools For Each Type Of Application.
When you do that, make sure the shock is oriented the way it will be in the vehicle, top side up. G11 2.56 rear axle g66 air shocks, rear. The correct way to install it is with the boot on top and the logo facing the correct way.
So, If You Are Not Sure Which Way Is Up On.
Prime the shock absorber before fitting. Lower the vehicle onto the jack stands, then lift the rear differential about one inch. Install the new shock by inserting the lower bolt first.
G67 Controller For Air Shocks.
Most cases it's better down, (like on race cars which use monotubes) so bilstein, kyb engineers and others will do this when it's better. Which way do the rear shocks go? Which way do you mount rear shocks?
Fold Down The Rear Seat Back.
If the shock mounts on studs and the nut is tough to thread on, clean the threads with a wire brush and apply penetrating oil/solvent. The oem shock on the truck may have the shock positioned with the rod. Does it matter which way rear shocks go?
Post a Comment for "Which Way Do Rear Shocks Go"